H4DV-26-C plingWall mounting Housing flange short mountin Helical gear box H4

Flender/Flender Gear Units/Helical gear box H4

ing on the gear unit size) on gear unit face 4 (end face d. Heat- ing elements cannot be mounted on gear unit face 4 if the unit is in mounting position in which gear unit face 4 is the standard mounting surface. Labyrinth seals are not permitted to be used with heating elements. Selection and ordering data Ordering information: When ordering heating elements and temperature monitoring, - and the following order codes must be added to the Article No. Viscosity ISO- VG at 4C in mm/ (cSt)Ambient temperatures Below -4 CUp to -4 Up to -3 Up to -3 Up to -2 Up to -2 Up to -1 Up to -1 Up to -5 Up to 0 Up to 5 Up to 1 Up to 1 Dip lubrication Mineral oil VG 4 2 2 1 1 VG 3 2 2 1 1 VG 2 2 2 1 1 PAO oil VG 4 2 1 1 VG 3 1 1 VG 2 1 1 PG oil VG 4 2 1 1 VG 3 2 1 1 VG 2 2 1 1 Oil circulation/forced lubricationMineral oil VG 3 2 2 1 1 VG 2 2 2 1 1 PAO oil VG 3 2 2 1 1 VG 2 2 2 1 1 PG oil VG 3 2 2 1 1 VG 2 2 2 1 1 No heating element required 1 One heating element required 2 Two heating elements required Not available as standard On request Data position of Article No. 1 to 6 7Order code Article No.: 2LP2 .-.....-....- Screw-in heater (standard version) One heating element at gear unit face 4 (end face d J0 Two heating elements at gear unit face 4 (end face d J0 One heating element at gear unit face 1 (end face d J0 Two heating elements at gear unit face 1 (end face d J0 One heating element at gear unit face 1 and gear unit face 4 J0 Oil temperature monitori ng (standard version) ATH-SW2 H4 Oil temperature indicator (standard version) Pt1 resistance thermometer H4 Pt1 resistance thermometer with transmitter H4 Screw-in heater (ATEX design, category 2 + One heating element at gear unit face 4 (end face d J0 5 Two heating elements at gear unit face 4 (end face d J0 6 One heatin