quantity B HWeight B Hth to th position of B3-DH-9-D Bevel-helical speed reduction gearbox B3

Flender/Flender Gear Units/Bevel-helical speed reduction gearbox B3

rating plate (see Section 3. Technical data). Finally, check the oil level (see 7.1.. Any oil escaping should be removed immediately with oil binding agent in an environmentally compatible way. 7.1.5 Drive with backstop Secure drive unit to prevent accidental startup. Affix notice at the switch-on point. Check the direction of rotation before putting into service! .. by manually turning the input shaft or the motor. Check the motor direction of rotation according to the phase sequence, swap two supply leads if necessary.Attention! Attention! Attention! Attention! Attention! Attention! BA G2 EN 0.0 2 / 4.2 Shutdown Shut down the gear unit by shutting off the drive unit. Secure drive unit to prevent accidental startup. Affix notice at the switch-on point. Note: If shut down for considerable period of time, the gear unit should be run briefly at intervals of three weeks. If shut down for period exceeding six months, the gear unit should be preserved (see 7.3 und 7.. 7.3 Preservation with gear oil Long term preservation up to 3 months. Completely top up the gear unit with the filled oil grade. Any oil escaping should be removed immediately with oil binding agent in an environmentally compatible way. 7.4 External preservation procedure Clean surfaces. Cleaning the drive with high-pressure cleaning device is not permissible. Do not use sharp-edged tools. Smear shaft seal rings with grease for protection against preservatives. Coating: check, in case of damage have it repaired by an expert. Apply preservatives. Protection time Preservative name Layer thickness Remarks uo to 1 Monate Tectyl 8 K1 approx. 5 mWax base long preservation, sea water resistant, tropic-proof, benzine-soluble Table 7.4: External preservation of shaft ends and other bright metal surfaces 8. Operation During operation, the gear units should be checked for excessive operating temperature (In continuous operation using mineral oil, the gear unit is suitable for temperature of 9 ; at higher