H4DV-22-C e oil temperature C Speed at low speed shaft LSS Helical gear unit H4

Flender/Flender Gear Units/Helical gear unit H4

ing air slide (Original place of installation) 1/2 I0 0/2 4.0 1 Air separator Including fan desig ned for feed of up to 6 /. Fine particles can be classified in to Blaine fineness of 2 to 4 cm/. The Separator (type QU -) was made by the high quality German supplier Schmidt & Co. in 1. An output between 3-4 / at 2 8 Blaine can be achieved. Air separator (Original place of installation) Scope supply : - Separator top part - Separator middle part - Separator bottom part - Central shaft - Cage wheel - Fan including motor - Twist adjusting device - Air circulating fan - Lubrication system 1/2 I0 0/2 Technical sp ecification: Fan: : 1.8 / : 1-1 Rpm Pw: 7 kW ptotal: 4 Pa Tmax: 1 Fan motor: Supplier: ABB Type: 3S-4 Pinstalled : 1 kW Speed: 1 Rpm Voltage: 4 ; 1 ; 5 Hz Cage drive: Supplier: Bauer Type: G9-2/DN 8 B4 -6 Pinstalled : 3 kW Speed: 1-3 Rpm Voltage: 4 ; 5.5 ; 5 Hz Twist adjusting device: Supplier: Auma Type: SAR 0.1 -E8-GF6,2 Pinstalled : 0.0 kW Speed: 1 Rpm Voltage: 4 ; 5 Hz Torque: 3 Nm Total weight: approx. 1 kg 1/2 I0 0/2 Process fan (Original place of installation) 1/2 I0 0/2 Process fans (after dismantling) Wear protection of the separator (after dismantling) 1/2 I0 0/2 Cage wheel of the separator (after dismantling) 1/2 I0 0/2 Middle part of the separator (after dismantling) 1/2 I0 0/2 Process fan (after refurbishing) Seperator casing (after refurbishing) 1/2 I0 0/2 3D drawing of the separator 3D drawing of mill and separator arrangement 2/2 I0 0/2 5.0 1 Set of Air slides 5.0 1 Air slide for mill discharge to circulating ucket elevator 5.0 1 Air slide for feeding air separator 5.0 1 Air slide for reject to mill inlet 5.0 1 Air slide underneath cyclone for finish product Set of air s