H4-SH-12B flender simpson Helical gear units H4

Flender/Flender Gear Units/Helical gear units H4

evels of the rolling-contact bearings: 1.Measure the vibrations at the rolling-contact bearings. 2.Document the measurement results. 3 HB series gearbox pare the measured values with the comparison values that were documented when commissioning the gear unit. 4.Archive the report together with these instructions. 5.Have Customer Services replace defective rolling-contact bearings. Further information You can find additional information on measuring the vibration levels at rolling-contact bear- ings in the operating instructions of the measurement sensor provided in the complete gear unit documentation. 8.3.8 Measuring the temperature at the rolling-contact bearings 8.3 Maintenance and servicing work Procedure Proceed as follows to measure the temperature at the rolling-contact bearings: 1.Measure the temperature at the rolling-contact bearings. 2.Document the measurement results. 3 HB series gearbox pare the measured values with the comparison values that were documented when commissioning the gear unit. 4.Archive the report together with these instructions. 5.Have Customer Services replace defective rolling-contact bearings. Servicing 8.3 Maintenance and servicing work B5-0 en Edition 0/2 7Further information Further information about measuring the temperature at the rolling-contact bearings can be found in the Pt1 resistance thermometer operating instructions in the complete document- ation for the gear unit. 8.3.9 Checking the ignition protection system 8.3 Maintenance and servicing work Procedure Proceed as follows to check the ignition protection system: 1.Check the ignition protection system for temperature monitoring to ensure that it is func- tioning correctly. 2.Check the ignition protection system for temperature monitoring for measurement accur- acy. Further information You can find additional information on checking the ignition protection system in the operat- ing instructions for the ignition protection system, provided in the complete gear unit docu- mentation. 8.3.1 Check that al