H3DV-6-C motoredutor flender Helical gear box H3

Flender/Flender Gear Units/Helical gear box H3

eason for complaint. Apparent leak Temporary leak. Clean below the sealing lip with clean rag. The sealing lip must not be soiled.Mostly due to excessive grease filling between seal and dust lip or oilsecretions from the greasefilling of labyrinth seals No reason for complaint. *)Siemens AG, Business Unit Mechanical Drives "MD" FVA = Forschungsvereinigung Antriebstechnik . . RWDR = radial shaft sealing ring Note Oil mist escaping from breather screw or labyrinth seal is functional and therefore not reason for complaint. 8 / 9BA 5 en 0/2. Maintenance and repair Observe the instructions in section 3. "Safety instructions" and in section 9."Faults, causes and remedy"! 1.1 General notes on maintenance All maintenance and repair work must be carried out carefully and by qualified personnel only (see section "Qualified Personnel" on page 3 of these instructions). The following applies to all work in item 1.2: DANGER Danger to life from switched on system For carrying out maintenance and/or repair work on the gear unit, the gear unit and any separate oil supply system must generally be shut down.The drive unit must be secured against unintentional start-up. notice should be attached to the start switch stating clearly that work is in progress. The periods indicated in table 1 largely depend on the conditions under which the gear unit is operated. Only average periods can therefore be stated here. These refer to the following values: daily operating time of 2 duty factor "ED" of 1 %an input-drive speed of 1 1/minan operating temperature of 9 (for mineral oil)an operating temperature of 1 (for synthetic oil) NOTICE Property damage Damage to the gear unit possible from non-compliance with the specified periods for maintenance and repair works is possible.The operator must ensure that the intervals stated in table 1 are adhered to. This also applies if the maintenance work is included in the operator' internal maintenance schedules. Table 1: Maintenance and rep