B3-VH22A pe Size d l G l l kg Solid shaft with parallel ke Bevel-helical speed reducer B3

Flender/Flender Gear Units/Bevel-helical speed reducer B3

ontact 9.1 Contact When ordering replacement parts, requesting customer service technician or if you have any technical queries, contact our factory or one of our Customer Service addresses: Flender Industriegetriebe GmbH Thierbacher Strasse 2 0 Penig Germany Tel.: +4 (0)3 / 6-0 Technical offer and Cost (0)3 / 8 More information Further information about service and support can be found on the Internet: Service & Support ( https:// Germany flender HB series gearbox /service ) Service & Support 9.1 Contact 8 Edition 0/2 B5-0 en B5-0 en Edition 0/2 8Disposal 1 Disposal of the gear unit When disposing of the gear unit after its useful life, please observe the following measures: Remove operating oil, preservative agents and coolant from the gear unit and dispose of it according to regulations. Dispose of the gear unit parts according to applicable national regulations or recycle them. Environmental protection Observe the following environmental protection measures for disposal: Dispose of or recycle packaging material according to applicable national regulations. When changing the oil, collect the used oil in suitable containers. Use oil-binding agents to clean up any oil spillages immediately. Store preservative agents separately from used oil. Dispose of used oil, preservative agents, oil binding agents and oil-soaked cloths ac- cording to the applicable environmental protection regulations. Disposal 8 Edition 0/2 B5-0 en B5-0 en Edition 0/2 8Spare parts 1 By stocking the most important spare parts at the installation site you can ensure that the gear unit is ready for use at any time. Information Damage to the gear unit due to use of unsuitable spare parts Only use original spare parts from Flender. Flender shall not accept any warranty claims for spare parts that are not supplied by Flender. Other spare parts are not tested and approved by Flender. Non-approved spare parts may possibly change the design characteristics of the gear unit and thus impair its active or passive safety. Flender will accept