B3-FH10-B with reinforced bearing see page Flender GmbH Bevel-helical gear Reduction Boxes B3

Flender/Flender Gear Units/Bevel-helical gear Reduction Boxes B3

s! The use of damaged parts is not permissible! Only the complete shrink disks supplied by the manufacturer may be used. Combining components from different shrink disks is not permitted. Thoroughly clean all parts. Do not use contaminated solvents or dirty cloths nor cleansing agents containing oil (such as paraffin or turpentine) for removing grease. The conical surfaces of the inner and outer rings (3 and 4, see Fig. must be free of grease and oil. thin layer of grease must be applied evenly to the conical surfaces of the inner and outer rings (3 and 4, see Fig. . Provide the tensioning bolts (5, see Fig. on the con tact surface and on the thread with lubricant. Use solid lubricant paste with high MoS 2based molybdenum disulphide content which will not slide during fitting work and which shows the following characteristics: Friction coefficient "" = 0.0 Resistant to pressure up to maximum pressure of 3 /mm Ageingresistant Table 2: Recommended lubricants for shrink disks after their cleaning Lubricant Form Manufacturer Molykote Rapid Spray or paste DOW Corning Aemasol MO 1 Spray or paste . . Matthes Unimoly 5 Powder Klber Lubrication gleitmo 1 Spray or paste Fuchs Lubritec Other lubricants may be used if they have the same characteristics. Join inner ring ( and outer ring (. Place the tensioning bolts and screw in some threads by your fingers. Observe the manufacturers instructions for handling lubricants! Mounting and startup must be carried out by properly trained specialist personnel. 7 / 1BA 5 en 0/2.9.4 Remounting the shrink disk For remounting the shrink disk the procedure described in item 6.9.1 must be adhered to. 6.9.5 Inspection of the shrink disk In all cases the inspection relating to the shrink disk should be carried out simultaneously with the examination of the gear unit, however at least every 1 months . Inspection of the shrink disk is limited to visual assessment of its condition. The following must be observe