tinued Low speed shaft LSS Oil quantity H H B2KV-13-C Bevel-helical speed reduction gearboxes B2

Flender/Flender Gear Units/Bevel-helical speed reduction gearboxes B2

ning notice to the start switch! The gear unit must be protected against falling objects. Protective devices for rotating parts must be checked for correct seating. Contact with rotating parts is not permitted. The periods indicated in table 9 depend on the conditions under which the gear unit is operated. Only average periods can therefore be stated here. These refer to: daily operating time of 2 duty factor of 1 %an inputdrive speed of 1 5 1/mina maximum oil temperature of 9 (mineral oil only) 1 (synthetic oil only) Note: For operation and maintenance, always observe the operating instructions indicated in the orderspecific appendix. For technical data, refer to the orderspecific list of equipment. The operator must ensure that the time periods stated in table 9 are adhered to. This also applies if the maintenance work is included in the operators internal maintenance schedules. Table 9: Maintenance and repair work Measures Periods Remarks Check oil temperature monthly Check for unusual gearunit noise monthly Check gear unit for leaks monthly Check oil level monthly Test oil for water content after approx. 4 operating hours, once per year at leastSee Item 1.2.1 First oil change 4 operating hours followingstartup See Item 1.2.2 Subsequent oil changes every 1 months or after ax. 5 0 operating hours See item 1.2.2 Cleaning the oil filter every 1 months or after max. 5 0 operating hours Clean fan, fan cowl and gearunit housing depending on requirementsor simultaneously with due oil changeSee Item 1.2.3 Check tightness of fastening bolts after first oil change, then after every second oil changeSee Item 1.2.5 Complete inspection of gear unit approx. every 2 yearssimultaneously with due oil changeSee Item 1.3.1 When using synthetic oils, the periods can be doubled.Caution! 2 / 3BA 5 EN 1.0.2 Description of maintenance and repair work 1.2.1 Testing water content of oil For detailed information on testing the oil for water content apply to the lubricant manufac