H4CV-10-C ical gear units B No of stages Design of Helical gear Reduction Box H4

Flender/Flender Gear Units/Helical gear Reduction Box H4

hapter-0.1 2, MECON Limited, All Right Reserved Page 7 of 2 All indications shall be LED type. Indication for charging by solar panels or by Grid power. Fuse failure As per the manufacturer standard 0.1.0.3 METERS (Digital Type) Load voltage and current PV Voltage and Current. MPPT Charger / amps MPPT Charger / Voltage Ah meter 0.1.0.4 CONSTRUCTIONAL FEATURES OF CHARGE CONTROLLER 1. Dust and vermin proof , IP-3 with forced cooling if required (Refer ambient condition as mentioned in the specification/PJS). 2. Sheet steel clad - Minimum 2 mm thick for panels - Minimum 1.6 mm thick for doors and side covers 3. Units shall be self contained and serviceable. 4. The arrangement and layout shall facilitate easy and conveni ent supervision of the unit while running as well as quick detectio of disturbances and troubles hooting. 5. Copper earth bus bar shall run through out the length of Pan els. All doors & non-current carrying parts shall be suitably earthed. 6. Dimensions of panels shall be such that it can be accommodated in existing room if indicated in data sheet. 7. The maximum and minimum operating height of the switches shall be 1mm and 3mm respectively. 0.1.0.5 ENCLOSURES AND VENTILATION Enclosure conforming to minimum IP-3 class. Units shall be provided with cooling fans with thermostat etc as per manufacturers standard. 0.1.0 FCBC CHARGER & PCU-MMPT INVERTER 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT TS NO.: MEC//2UU/0/2/0 Solar photo voltaic ( SPV) power supply system Chapter-0.1 2, MECON Limited, All Right Reserved Page 8 of 2 0.1.0.1 FCBC CHARGER Not included in scope 0.1.0.2 PCU-MMPT INVERTER PCU / MPPT and 3 phase inverter shall be supplied as integrated unit depe nding upon the size of the solar power system. It should conform to IEC6 and must addi t