Bevel-helical gear Reduction Box B4 eed shaft LSS at both ends the direction of rota B4FH-20-C

Flender/Flender Gear Units/Bevel-helical gear Reduction Box B4

with re levant specified standards to prove the design nd general qualities of the cabl es Routine test as per the applicable standard indicated in the te chnical specification shall be carried out on each drum of cables. ) Acceptance test 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 2 of 2 Acceptance tests as per the applicable standard indicated in the technical specification shall be carried out on the drum chosen randomly as per the sampling plant for acceptance of the lot. ) Type Test Type tests certificates for each type of cable, as per the applicable standard shall be furnished by the contractor ) Motors ) Routine Tests 1 Measurement of resistance. 2 Insulation res istance test. 3 Motors are tested at 1/3 times the rated voltage for chec king the ability of the motor to run upto full speed , when switched in either directio . 4 No load test. 5 High voltage test. ) Type Tests 1 Measurement of rotor resistance. 2 No load test 3 Locked rotor test . 4 Full load reading of voltage, urrent , power input and slip. 5 Temperature rise test. 6 Momentary overload test . 7 Insulation resistance test . 8 High voltage test . 9 Polarisation index test (for HT motors) Note: Hazardous Area Equipment, lectrical system relevant Site Tests shall be done as per norms and procedure of IL & GAS installation. any specific test mentioned 5.0 SITE TESTS AND CHECKS 5.0.0 General 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT _____________________