ta ge gear unit sizes to Selection and ordering B3-HH8A Bevel-helical gear unit B3

Flender/Flender Gear Units/Bevel-helical gear unit B3

pped with an oil level monitor- ing system based on level monitor, level switch or filling-level limit switch. The oil level monitoring system has been designed to check the oil level when the gear unit is at standstill before it starts. Mounting position When an oil level monitoring system is used, particularly ensure that the gear unit is moun- ted in the specified position. Principle of operation Connect the signal so that the drive motor cannot start when the "oil level too low" signal is active. Further information You can find additional information and detailed illustration of the gear unit and the position of the mounted components in the drawing in the complete documentation for the gear unit. You can find additional information on the oil temperature monitoring system and technical data in the operating instructions for the oil temperature monitoring system and in the list of equipment, which are part of the complete documentation of the gear unit. Description 3.1 Axial load monitoring A5-0 en Edition 0/2 3.1 Axial load monitoring 3.1 Axial load monitoring Introduction Depending on the order specification, the gear unit can be equipped with an axial load monit- oring system. The axial load from the worm shaft is monitored by built-in load cell. Connect this to an evaluation unit provided by the customer. Further information You can find additional information and detailed illustration of the gear unit and the position of the mounted components in the drawing in the complete documentation for the gear unit. You can find additional information about axial load monitoring and technical data in the op- erating instructions for the axial load monitoring system and in the list of equipment in the complete documentation for the gear unit. 3.1 Bearing monitoring 3.1 Bearing monitoring 3.1.1 Bearing monitoring by shock-pulse transducer 3.1 Bearing monitoring Depending on the order specification, the gear unit can be equipped with measuring nipples for monit