H V with dip lubrica tionOil quantity H V B3HH-8-C Bevel-helical gear box B3

Flender/Flender Gear Units/Bevel-helical gear box B3

pply, which terminates in the recess of the hollow shaft (see figure . This connection may also be used for supplying rust releasing agent. Fig. 2: Hollow shaft with internal spline, preparation 1 Machine shaft 2 Hollow shaft3 DU bush 4 Pressurised oil connection 4 / 9BA 5 en 0/2.6.2 Fitting WARNING Serious physical injury Risk of physical injury from inflammation caused by solvent steams during cleaning work. Observe the following:- Ensure adequate ventilation. - Do not smoke. Remove the corrosion protection from the hollow shaft and machine shaft with suitable cleaning agent. CAUTION Risk of injury from chemical substances Observe manufacturer' instructions for handling lubricants and solvents. Wear suitable protective clothing. NOTICE Property damage Damage to the shaft sealing rings from chemically aggressive cleaning agents is possible.Any contact of the cleaning agent with the shaft sealing rings must be avoided. Check the hollow and machine shafts for any damage on the seats and edges. If necessary, rework the parts with suitable tool and clean them again. Note Coat with suitable lubricant to prevent frictional corrosion of the contact surfaces. 6.6.2.1 Fitting with integrated DU bush Fit the gear unit by means of nut and threaded spindle. The counterforce is provided by the hollow shaft. NOTICE Property damage Damage to the gear unit from canting during assembly is possible. When fitting the gear unit, attention must be paid to the alignment of the hollow shaft to the machineshaft and the matching position of the machine shaft' teeth relative to the hollow shaft. The correct position can be determined by turning the input shaft or by swivelling the gear unit lightly around the hollow shaft. 4 / 9BA 5 en 0/2 Fig. 2: Hollow shaft with internal spline, fitting with integrated DU bush 1 Machine shaft 2 Hollow shaft3 DU bush 4 Nut5 Threaded spindle 6 Nut7 End plate 6.6.2.2 Fitting with loose DU bush The loose DU bush is pushed onto the machine sha