alues exact data acc to orderrelated documentatio B3-DH12A Bevel-helical gear unit B3

Flender/Flender Gear Units/Bevel-helical gear unit B3

ratios, high power rating and high input speed may lie in the hatched range. If no proper measuring system can be established when measuring again at the place of use, the measurement on the FLENDER TBINGEN GMBH test rigs are valid. 6LWA [dB] [kW]0.2 0.5 1 2 5 1 2 5 1 1 0.1 Figure 3.5 LWA [dB] Sound power level [kW] Mechanical power rating External noises Noises which are not generated by the gear unit but are emitted by the gear unit are not taken into consideration. Noises which are emitted by input and output machines as well as by the foundation are not taken into consideration either, even if they were transmitted to that point by the gear unit. General guidelines concerning the influence of noise on people should be taken into consideration. BA G2 EN 0.0 1 / 4. Incoming goods, handling and storage 4.1 Incoming goods The contents of the shipment are listed in the shipping documents. The shipment should be checked for completeness and shipping damage immediately on receipt. If necessary, loss advice should bewritten out in the presence of the forewarder, otherwise repairing the damage without costs will not be possible. Damaged drives must not be put into operation. 4.2 Handling The drive is shipped in assembled state. Ancillary equippment (such as for example pipes and valves) are shipped packed separately. The packing of the gear unit will differ, dependent on the method of shipment and size. The packing, unless otherwise agreed contractually, complies with HPE Packing Guidelines . The symbols shown on the packing should be noted. Their significance is as follows: This side up Fragile Goods Keep dry Protect Centre of gravity Use no hooks Sling here from heat When handling and loading and unloading of the drive, excercise special care to avoid damage due to the use of force. The drive system must be attached to the transport fixture with the maximum permissible suspension weight. As rule this is on the main gear unit. Check the eye-bolt provided for firm se