B3-CV-6-D cation by external flange mounted pump LP Bevel-helical gear reducer B3

Flender/Flender Gear Units/Bevel-helical gear reducer B3

Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Double Reduction Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Lifetime Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 WARNING: Cancer and Reproductive Harm FLENDER GRAFFENSTADEN P6Warnings.ca.gov General Instructions 1 . Align all shafts accurately . Improper alignment can result in failure . Use of flexible couplings is recommended to compensate for slight misalignment . 2 . When mounting, use maximum possible bolt size and secure reducer to rigid foundation . Periodic inspection of all bolts is recommended . 3 . Auxiliary drive components (such as sprockets, gears and pulleys) should be mounted on the shafts as close as possible to the housing to minimize effects of overhung loads . Avoid force fits that might damage bearings or gears . 4 . For hollow-shaft speed reducers, place speed reducer as close as possible to supporting bearing on drive shaft . Spot- drill driven shaft for setscrews in severe applications . See kit instructions for reaction rod assembly . 5 . Check and record gear backlash at installation and again at regular intervals . This should be done by measuring the rotary movement of the output shaft (rotating alternately clockwise and counterclockwise) at suitable radius while holding the input shaft stationary . Gears should be replaced when the backlash exceeds four times the measurement taken at installation . 6 . Gear drives are rated for 1 input RPM and Class Service (Service Factor 1 .0), using Klubersynth UH1 6-4 synthetic lubricant . For lower input speeds or for different service classes or lubricants, see catalog selection pages for rating information . 7 . Initial operating temperatures may be higher than normal during the break-in period of the gear set . FOR