Helical speed reduction gearbox H4 y cooling Depending on the operating conditions a H4-FH-24B

Flender/Flender Gear Units/Helical speed reduction gearbox H4

kept free from dirt and paint at all times. Missing plates must be replaced. Screws which have been damaged during assembly or disassembly work must be replaced with new ones of the same strength class and type. Spare parts must be obtained from Siemens (see section 1. "Spare parts, customer service"). 3.2 Environmental protection Dispose of any packaging material in accordance with regulations or separate it for recycling. When changing oil, the used oil must be collected in suitable containers. Remove any pools of oil immediately using an oil binding agent. Preservative agents should be stored separately from used oil. Used oil, preservative agents, oil binding agents and oil-soaked cloths must be disposed of in accordance with environmental legislation. Disposal of the gear unit after its useful life: Drain all the operating oil, preservative agent and/or cooling agent from the gear unit and dispose of in accordance with regulations. Depending on national regulations, gear unit components and/or add-on parts may have to be disposed of or sent for recycling separately. 1 / 5BA 5 en 0/2.3 Special dangers and personal protective equipment Depending on operating conditions, the surface of the gear unit may heat up or cool down to extreme temperatures. WARNING Risk of burns Serious injury caused by burns on hot surfaces (> 5 ) is possible. Wear suitable protection gloves and protection clothing. WARNING Risk of low temperatures Serious injury from cold damage (pain, numbness, frostbites) on cold surfaces (< 0 ) is possible.Wear suitable protection gloves and protection clothing. WARNING Risk of scalding Serious injury from discharging hot operating media when these are changed is possible.Wear suitable protection gloves, protection glasses and protection clothing. WARNING Risk of eye injury Small foreign matter such as sand or dust can get into the cover plates of the rotating parts and bethrown back by these.Wear suitable protective glasses. Note In addition