flender n eupex 95 H3-HV24A Helical gear Reduction Box H3

Flender/Flender Gear Units/Helical gear Reduction Box H3

e ly on the insulators without warping and if necessary, suita ble packing shall be provided at the insulators. Final tightening of the bolts shall be done after the complete laying of buses. Approved means shall be used for tightening of the bolts with recommende tightening pressure as per the manufacturer recommendations. Bimetallic strips/ washers shall be used wherever aluminiumbusb ars or aluminium cables are terminated on copper busbars. 0.0.0 Crane Trolley Lines While sectionalizing, on middle safety section shall be arranged slightly in excess of the crane braking distance so that it can act as buffer and prevent the danger of crane collector bridging the isolator gap and leading to accidents on other section under repair or maintenance. Boarding or access platform shall be arranged within the limits of each repair section for approach to the crane. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 2 of 2 In the middle of the run betwee two expansion joints and at se ctionalizing gaps, the rails shall be rigidly fastened/supported. 0.0.0 Resistance boxes The resistance boxes shall be installed on frames to be welded to civil inserts already provided. 0.0.1 Cables Installations Interplant cabling shall be done in Overhead cable galleryor Ca ble tunnel or Concrete cable trench as specified in TS. Cables of small in numbers and cables for drives/field switches inside shop units shall be laid along the structures and co lumns of the shop / buildings. Cables may run partly in walkable cable tunnels or underground trenches and/or surface ucts in the shops and partly along