Helical gear units H3 flender industriegetriebe gmbh H3-CH-22-D

Flender/Flender Gear Units/Helical gear units H3

d. Attaching the load For transport, only attach the gear unit at the marked attachment points intended for this pur- pose. Ensure the following measures are taken when attaching, lifting, lowering and moving the load: Keep within the load limits When using loading suspension devices with several load hooks, ensure the load is evenly distributed Be aware that the centre of gravity may not be in the centre Ensure that lifting equipment is correctly secured Move the equipment slowly Load sway and attachment of the load to objects or parts of buildings is not permissible Load hooks must not be loaded at the tip Only set down products on flat, non-slip and strong base DANGER Falling load There is risk of fatal injury from falling loads if these have not been securely attached to the lifting equipment. Never stand or sit under suspended loads. Do not exceed the load limits of the lifting equipment. Packaging The gear unit is delivered fully assembled. Any additional equipment is supplied in separate packaging where applicable. The way the gear unit is packaged may vary, depending on the transport route and size. Application planning 4.3 Attachment points A5-0 en Edition 0/2 3The symbols which appear on the packaging must be observed. 7KLVZD\XS )UDJLOH .HHS GU\.HHS FRRO&HQWUHRI JUDYLW\'RQRW XVHKDQGKRRNV$WWDFKKHUH Figure4-1: Transport symbols 4.3 Attachment points 4.3 Attachment points Lifting eyes Lifting eyes are fitted to the individual housing sections and used to transport the unit during assembly. Carefully ensure that the angle of the vertical load at the gear units lifting eyes does not ex- ceed 4. Sling swivels Gear units have tapped holes to specifically attach lifting eyes so that they can be transpor- ted during assembly. The shear pulling must not exceed 4 when the lifting equipment is attached to sling swiv- els. Information Damage to the gear unit during transport If incorrect attachment points are used, gear units can be damaged when they are transpor- t