H2-SV-9-A flender fluid coupling catalogue pdf Helical gear box H2

Flender/Flender Gear Units/Helical gear box H2

0 6.5-8.0 6. Weight per liter in kgs/litre (max paint) (minimum) 1.5 1.7 1.3 1.7 7. Touch dry at 3C (maximum) 4 hrs. 2 hrs. 1 hr. 2 hrs. 9 of 1 STANDARD TECHNICAL SPECIFICATION MECON LIMITED REGD. OFF: RANCHI 8 OIL & GAS SBU, DELHI DOCUMENT NO. Page 2 of 5 TITLE MEC//0/2/0 REVISION : 0 SHOP & FIELD PAINTING EDITION : 1 Sl. No. Description -1 -1 -1 -1 8. Hard dry at 3C (maximum) Full cure 3C (for immersion / high temp. service) 2 hrs. 1 hrs.(7 days) 2 hrs. 1 hrs.(7 days) 1 hrs. - 2 hrs. 1 hrs.(7 days) 9. Over-coating interval Min. 6 hrs. Max. 5 days Min. 3 hrs. Max. 2 days Min. 1 hrs. Max. Not applicable Min. 1 hrs. Max. 2 days. 1. Pot life at 3C for two component paints (minimum) 4 hrs. 1.5 hrs. 1 hr. 1 hr. 1. Temperature Resistance (min.) -4C to 1C under insulation -4C to 1C under insulation (Note : Up to 4C for CS & SS under insulation -4C to 1C for immersion service Notes: 1. Covering capacity and DFT depends on method of application. Covering capacity specified above are theoretical. Allowing the loose during the application, minimum specified DFT should be maintained. 2. All primers and finish coats should be cold cured and air drying unless otherwise specified. 3. All paints shall be applied in accordance with manufacturers instruction for surface preparation, intervals, curing and application. The surface preparation, quality and workmanship should be ensured. 4. Technical data sheets for all paints shall be supplied at the time of submission of quotations. 6.4 List of recommended manufacturers The paint shall conform to the specifications given above and the best quality in their products range of the manufacturers listed in Annexure-. 7.0 PAINT SYSTEM The paint system should vary with type of environment envisaged in and around the plants. Three types of environment as given below are considered for selection of paint system. The paint system is al