H2-SV-10B flender indonesia Helical gear units H2

Flender/Flender Gear Units/Helical gear units H2

0 Type Non drawout type 2.0 Construction Modular construc tion. Fully compartmentalized with metal / insulatin material partition. 3.0 Enclosure class IP5. 4.0 Type of execution Single front. 5.0 Mounting Floor mounting. ree standing with ISMC 7. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 1 of 2 6.0 Installation Indoor. . Constructional Features :- 1.0 Sheet steel Thickness 2.0 mm for load bearing members. 1.6 mm for non load bearin members. Material CRCA 2.0 Cable entry Incomer :- Bottom cable entry. Outgoing :- Bottom cable entr . 3.0 Design Separate enclosed/is olated cable alley (minimum 2mm wide) for each vertical. Cable alley & module doors shall open opposite to each other. Extendable at both ends. Rear access through remova ble rear hinged cover door. All the components shall be accessible from front. Motor controller shall be flush mounted on the respective door. Interchangeable facility of same type of feeder modules in case of draw out design. Each module (draw out) to have covering at the bottom. ACB cubicle door shall also close when the ACB is in isolated position. 4.0 Interlocking & protection Module door interlocked with main power isolating devices with defeat facility. Power circuit isolation device to have pad locking in the OFF position with door closed. 5.0 Operating height Minimum :- 3mm.or as per type tested design conforming to IEC 6 Maximum :- 2 mm. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________