H2-KV-19-D flender geared motor catalogue Helical gear units H2
In stock
SKU
H2-KV-19-D
$141,428.57
Flender/Flender Gear Units/Helical gear units H2
At low temperature the oil in the girth gear cover runs back slowly. Before the oil is drained off, it
mustbe checked to determine whether the original level on the oil-supply system has again been reached. It may be re-used 
only as flushing oil after thorough cleaning. 7.1.2.3 Flushing before/after repair/maintenance work Flushing before and after the repair and maintenance 
work serves mainly to remove any possible contamination. Flushing should be carried out with the selected service lubricant. It is 
recommended that the oil be warmed up. The flushing time depends on the level of contamination. NOTICE Property damage Damage to the gear unit from mixing oils is possible. At low temperature the oil in the girth gear cover runs back slowly. Before the oil is drained off, it mustbe checked to determine whether the original level on the oil-supply system has again been reached. It may be re-used only as flushing oil after thorough cleaning. 3 / 5BA 5 en 0/2.2 Inductive sensor on the intermediate shaft (optional) Note This item need be observed only, if an inductive sensor is used on the intermediate shaft. During operation the axial displacement of the floating shaft ( is monitored by means of an inductive sensor (. 3, 3 3 3 ba Fig. 1: Inductive sensor on the intermediate shaft (optional) 7.2.1 Setting the inductive sensor The girth gear unit has been completely installed in front of the mill and clamped in the direction of load. The covers (3, have been marked with letter punches. This marking is equivalent of the dimension "" when the floating shaft ( is in centred position. Due to alignment and girth gear tooth errors the floating shaft ( in case of gear unit installed in front of the girth gear may have been displaced from the central position. To check the displacement of the floating shaft ( check measurement must be carried out. Remove pick-up bush ( and/or screw plug (. Determine dimension "" with depth gauge. The displacement from the| Model Type | Helical gear units H2 |
|---|---|
| Gear Type | Helical Gear |
| Weight (kg) | 6600.000000 |
| Ratio Range | 1 : 6.3…20 |
| Low Speed Output | Hollow shaft with spline acc. to DIN 5480 |
| Nominal Torque | 292000 Nm |
| Mounting Arrangements | Vertical mounting position |
| Manufacturer | Flender France S.A.R.L. |
| Country of Manufacture | Hungary |
| Data Sheet & Drawings | H2-KV-19-D flender geared motor catalogue Helical gear units H2 |
Related Products
