H1-SH9A n eupex a180 Helical speed reduction gearboxes H1

Flender/Flender Gear Units/Helical speed reduction gearboxes H1

__ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 1 of 2 1.0 Sheet steel Thickness - 2 mm for load bearing members. -1.6 mm for non load bearin members. Material CRCA 2.0 Cable entry - Incomer :- Botto cable entry. -Outgoing :- Bottom cable entr . 3.0 Design - Separate bus alley and cable alley on opposite side of the out going modules. - All the components shal be accessible from front. - Each module to have covering at the bottom. - Minimum 2mm shall be left blank at bottom throu gh the len gth of panel. 4.0 Interlocking & protection - Module door interlocked with main power isolating devices. - Power circuit isolation device to have pad lockin in the OFF position with door closed. 5.0 Operating height - Minimum :- 3mm -Maximum :- 2 mm. 6.0 Gland plate Undrilled remova ble bottom gland plates (3 mm thick) 7.0 Miscellaneous - Neosprene rubber gasket shall be provided for all the doors , removable covers & between adjacent covers . - Lifting hooks for the panel . -Doors shall have concealed hin ges . 8.0 Labelling Clear legible identification labels (anodized aluminium with white letters engraved on black background ) with let ter sizes of :- - 2-5 mm for MLDB panel - 5 mm for components and module name plates. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 1 of 2 - Danger board on front and rear sides in En glish, Hindi and local lan guage . 9.0 Earthing - Two separate earthing erminals shall be provided. - Bolted joints with tooth spring washers for go