B4SH-8-C to Selection and ordering data Dimensions in mm G Bevel-helical gear reducers B4

Flender/Flender Gear Units/Bevel-helical gear reducers B4

so given for specific requirements. 9 of 1 STANDARD TECHNICAL SPECIFICATION MECON LIMITED REGD. OFF: RANCHI 8 OIL & GAS SBU, DELHI DOCUMENT NO. Page 2 of 5 TITLE MEC//0/2/0 REVISION : 0 SHOP & FIELD PAINTING EDITION : 1 Primers & finish coats covered in table nos. 7.0 to 1.0 PRIMERS -2 : Chlorinated Rubber Zinc Phosphate Primer -4 : Etch Primer/ Wash Primer -6 : Epoxy Zic Phosphate Primer FINISH COATS/ PAINTS -2 : Acrylic- Polyurethane finish paint -3 : Chlorinated Rubber Finish Paint -6 : High Build Epoxy finish coating -7 : High Build Coal Tar epoxy coating -8 : Self-priming surface tolerant high build epoxy -9 : Inorganic Zinc Silicate Coating. -1 : Heat resistant Synthetic medium based Aluminum paint. -1 : Heat resistant Silicone Aluminum paint. -1 : Specially formulated polyamine-cured coal for -1 : Epoxy phenolic coating -1 : Epoxy Siloxane Coating : Amercoat 7 -1 : Two component solvent free type high built epoxy phenolic / novalac epoxy phenolic coating cured with polyamine. 9 of 1 STANDARD TECHNICAL SPECIFICATION MECON LIMITED REGD. OFF: RANCHI 8 OIL & GAS SBU, DELHI DOCUMENT NO. Page 2 of 5 TITLE MEC//0/2/0 REVISION : 0 SHOP & FIELD PAINTING EDITION : 1 TABLE 7.1: PRE-ERECTION/ PRE-FABRICATION AND SHOP PRIMING FOR CARBON STEEL, LOW TEMPERATURE CARBON STEEL & LOW ALLOY STEEL, STEEL STRUCTURE, PIPING AND EQUIPMENT ETC. . No. DESIGN TEMPERATURE IN SURFACE PREPARATION PAINT SYSTEM TOTAL DFT IN MICRONS (MIN.) REMARKS 7.1.1 -9 TO 4 SSPC-SP-1 1 COAT OF -9 6-7 No overcoating is to be done 7.1.2 4 To 5 SSPC-SP-1 1 COAT OF -1 4-5 Finish Coat at Site 7.1.3 -4 to 1 for Structures, hand rails and Grating only SSPC-SP-3 1 COAT OF -9 OR 2 COATS OF -7 FLENDER GRAFFENSTADEN 4 DFT / COAT 6-7 OF -9 OR 8 (- For Damaged Area of more than 5 5 Cm2. TABLE 7.2: REPAIR OF PRE-ERECTION/ PRE- FABRICATION AND SHOP PRI