on request the design can have a filter with a fi B4DV-12-C Bevel-helical gearboxes B4

Flender/Flender Gear Units/Bevel-helical gearboxes B4

ues for oil quantity required in case of vertical mounting position of the agitator gear units with forced lubrication TypeOil quantity (approximate value) in litres for size 7 8 9 1 1 1 1 1 1 1 1 1 H2RV H2TV3 3 4 5 8 9 1 1 1 2 2 2 H2GV H2JV2 2 4 4 6 7 8 9 1 1 1 1 H3RV H3TV4 4 7 8 1 1 1 1 2 2 3 3 H3GV H3JV2 3 4 4 6 7 1 1 1 1 1 2 H4RV H4TV3 4 6 6 1 1 1 1 1 1 2 2 H4GV H4JV2 2 3 4 6 7 9 1 1 1 1 2 Table 3: Approximate values for oil quantity required in case of vertical mounting position of the aerator gear units with forced lubrication TypeOil quantity (approximate value) in litres for size 5 6 7 8 9 1 1 1 1 1 1 1 H2BV 1 1 2 2 4 4 6 7 9 1 1 1 H3BV 1,5 1 2 2 3 4 6 7 8 1 1 1 B3BV 1 1 2 3 3 4 6 7 9 1 1 1 Table 3: Approximate values for oil quantity required in case of vertical mounting position of the pulper gear units with forced lubrication TypeOil quantity (approximate value) in litres for size 8 9 1 1 1 1 1 1 1 1 1 B2PV 2 4 4 7 8 9 1 1 1 1 1 7.2 Startup Before startup, replace the yellow plastic screw plug with the air filter (see also notice on gear unit). 7.2.1 Oil level Check the oil level in the gear unit with the oil dipstick. To do so, the gear unit must be shut down. When the oil is cool, the level should be at the upper mark on the oil dipstick. When the oil is warm it may slightly exceed this mark. It must in no case be allowed to fall below the mark. If necessary, top up to the correct level. 8 / 1BA 5 en 0/2.2.2 Gear unit with cooling coil or external oilsupply system The permissible pressure and temperature values specified in the data sheet and/or list of equipment must not be exceeded.This is to be checked before the startup. Fully open the stop valves in the coolant in and outflow pipes of the cooling system. Check that connecting lines are correctly fastened and tight. For connecting dimensions, refer to the dimensioned drawing of the gear unit. The required cooling water quantity and the max. permissible inlet temperature are given on the data shee