Bevel-helical gear units B4 be prevented using a backstop that is integrated B4-FH-17B

Flender/Flender Gear Units/Bevel-helical gear units B4

wire sp eed performance with minimum switching capacity of Gbps & minimum Mpps forwarding rate (the switching capacity and forwarding rate shall be as per the number of ports provided); Should be IPV4, IPV6 Compliant from Day One Should support minimum 4 MAC address and minimum 1 VLAN; Should support Jumbo Frame, Port Mirroring, and Broadcast / Mul ticast/ Unicast Storm Control. Should support Multicast [Minimum supported Multicast Groups: 2]. Should support LLDP-MED. Should support port-mirroring. Should support -3 redundancy featu res (VRRP for IPV4 & IPV Should support both static and dy namic link aggregation & Load balancing Should support CoS&DiffServ. Should support Standard and Extended Access control list for bo th IPv4 / IPv6: Access control list with IP based ACL, MAC Based ACL and IP + MAC combination based ACL, time based ACL etc. Should be IPv4 / IPv6 ready (dual stack) supporting Static routing & Dynamic routing protocols ( SPF & BGP) for IPv4 and IPv6. Should support iSCSI connectivity. (vii) Supported Standards: IEEE 8.1D Spanning Tree Protocol IEEE 8.1p CoS Prioritization IEEE 8.1Q VLAN IEEE 8.1s IEEE 8.1w IEEE 8.1x/IEEE 8.1x-Rev IEEE 8.3ad IEEE 8.3af 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT _____________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Energy management sys tem, IT and telecom se rvices Chapter0.1 2, MECON Limited, All Right Reserved Page 1 of 2 IEEE 8.3x full duplex on 1BAS -, 1BASE-TX, and 1BASE- ports IEEE 8.3 1BASE- specification IEEE 8.3u 1BASE-TX specification IEEE 8.3ab 1BASE- specification IEEE 8.3ae IEEE 8.3z 1BASE- specification IEEE 8.3x Flow Control (viii) Management Featured: Supporting SNMPv1, v2 and v3 Supporting IGM