B4-DH-19B cod e YSide Radial shaft seal Z QB Side Radial Bevel-helical gear boxes B4

In stock
SKU
B4-DH-19B
$145,714.29

Flender/Flender Gear Units/Bevel-helical gear boxes B4

ty shown on the rating plate is to be understood as an approximate quantity. Decisive for the oil quantity to be filled in is the middle of the oil sight glass or the middle between the MIN and MAX marking on the oil dipstick. The BA 7 manual relating to the gear unit lubrication and table " 7" containing the current lubricant recommendations of Siemens can also be consulted on the internet (see back cover). The oils listed there are subjected to continuous tests. Under certain circumstances the oils recommended there may therefore later be removed from the range or replaced with further developed oils. We recommend checking before any oil change whether the chosen lubricant is still approved by Siemens. 6 / 7BA 5 en 0/2. Spare parts, customer service 1.1 Stocking spare parts By stocking the most important spare and wearing parts on site you can ensure that the gear unit is ready for use at any time. To order spare parts, refer to the spare-parts list. For further information refer to the spare-parts drawing stated in the spare parts list. NOTICE Property damage Damage to the gear unit from improper use. Siemens guarantee only the original spare parts supplied by Siemens. Non-original spare parts have not been tested or approved by Siemens. Non-original spare parts may alter technical characteristics of the gear unit, thereby posing an active or passive risk to safety.Siemens will assume no liability or guarantee for damage caused by spare parts not supplied by Siemens. The same applies to any accessories not supplied by Siemens. Please note that certain components often have special production and supply specifications and that Siemens supplies you with spare parts which comply fully with the current state of technical development as well as current legislation. When ordering spare parts, always state the following: Order no., position Type, size Part no. Quantity 1.2 Addresses for ordering spare parts and customer service When ordering spare parts or requesting s
More Information
Model Type Bevel-helical gear boxes B4
Gear Type Bevel Helical Gear
Weight (kg) 6800.000000
Ratio Range 1 : 80…315
Low Speed Output Hollow shaft with shrink disk
Nominal Torque 300000 Nm
Mounting Arrangements Horizontal mounting position
Manufacturer Flender ATB-Loher
Country of Manufacture Honduras
Data Sheet & Drawings B4-DH-19B cod e YSide Radial shaft seal Z QB Side Radial Bevel-helical gear boxes B4