Bevel-helical gear box B4 rder via order cod e YSide Radial shaft seal Z PB B4-DH-14-A

In stock
SKU
B4-DH-14-A
$58,607.14

Flender/Flender Gear Units/Bevel-helical gear box B4

ture is less than 5 above dew point when the relative humidity is greater then 8% or when the temperature is below 4 . 5.7.2 Blast cleaned surface shall be coated with one complete application of primer as soon as practicable but in no case later than 4 hrs. the same day. 5.7.3 To the maximum extent practicable, each coat of material shall be applied as continuous film uniform thickness free of probes. Any spots or areas missed in application shall be recoated and permitted to dry before the next coat is applied. Applied paint should have the desired wet film thickness. 5.7.4 Each coat shall be proper state of cure or dryness before the application of succeeding coat. Material shall be considered dry for recoating when an additional coat can applied without the development of any detrimental film irregularities such as lifting or loose of adhesion of the under coat. Manufacturer instruction shall be followed for intercoat interval. 5.7.5 When the successive coat of the same colour have been specified, alternate coat shall be tinted, when practical, sufficiently to produce enough contrast to indicate complete coverage of the surface. The tinting material shall be compatible with the material and not detrimental to its service life. 9 of 1 STANDARD TECHNICAL SPECIFICATION MECON LIMITED REGD. OFF: RANCHI 8 OIL & GAS SBU, DELHI DOCUMENT NO. Page 9 of 5 TITLE MEC//0/2/0 REVISION : 0 SHOP & FIELD PAINTING EDITION : 1 5.7.6 Air spray application shall be in accordance with the following: . The equipment used shall be suitable for the intended purpose, shall be capable of properly atomizing the paint to be applied, and shall be equipped with suitable pressure regulators and gauges. The air caps, nozzles, and needles shall be those recommended by the manufacturer of the equipment for the material beign sprayed. The equipment shall be kept in satisfactory condition to permit proper paint application. . Traps or separators s
More Information
Model Type Bevel-helical gear box B4
Gear Type Bevel Helical Gear
Weight (kg) 2735.000000
Ratio Range 1 : 100…400
Low Speed Output Hollow shaft with shrink disk
Nominal Torque 113000 Nm
Mounting Arrangements Horizontal mounting position
Manufacturer A. Friedr. Flender GmbH
Country of Manufacture Germany
Data Sheet & Drawings Bevel-helical gear box B4 rder via order cod e YSide Radial shaft seal Z PB B4-DH-14-A