nations right and left always refer to the horizo B3SV-17-C Bevel-helical gearboxes B3

Flender/Flender Gear Units/Bevel-helical gearboxes B3

oil, API groups or II and satur- ated synthetic ester 1C is applicable for semi-synthetic oils, API group III, PAO and PG oils Water pressure of the cooling coil or the water-oil cooler<8.0bar Table7-2: Operating data for temperature classes T1, T2, T3 and/or maximum surface temperature 1C, 2C You will find information about the oil pressure in the data sheet, in the list of equipment or in the dimension drawing in the complete documentation for the gear unit. DANGER An explosive atmosphere can be ignited An explosive atmosphere can be ignited by electrostatic discharge. Do not electrostatically charge the coating. Carefully ensure that highly efficient charge generating mechanisms, which can cause layers and coatings to be electrostatically charged, are reliably avoided. Highly efficient charge generating mechanisms include the following: Operation 7.2 Irregularities in operation 7 Edition 0/2 B5-0 enFast flows of highly dust-laden air Sudden discharge of compressed gases that contain particles Other operations that involve high frictional forces (does not include manual cleaning or rubbing with cleaning cloths) Further information Further information about the technical data of the gear unit can be found in the data sheet and the list of equipment in the complete documentation for the gear unit. 7.2 Irregularities in operation 7.2 Irregularities in operation Introduction Switch off the drive aggregate immediately if it exhibits irregular behaviour during operation. few irregularities are listed below as examples: Oil temperature exceeds the maximum permissible value Alarm tripped by the pressure monitor in the oil cooling system or oil supply system Unusual operating noise NOTICE Faults can cause damage to the gear unit The gear unit might sustain damage if it is not shut down when fault occurs. Switch off the drive assembly immediately if any fault condition develops. Rectifying irregularities in operation Proceed as follows to rectify any irregularities in o