ide is on top Mounting cover on top looking a B3-SV18A Bevel-helical gear reducers B3

Flender/Flender Gear Units/Bevel-helical gear reducers B3

oil. MONTHLY: Inspect: ( All blades for wear replace when worn. ( Pan rim, base and door wear plates replace when worn ( Pan Roller Bearings replace if necessary ( Pan Door Bearing replace if necessary ( Pneumatic system for leaks repair or replace damaged parts. ( Pneumatic Cylinders. Make sure that the door cylinder piston rod is at the end of its travel when the discharge door is just home in its seating. ( Check the .. bushing securing the Mixing Star and Pan Drive to theirrespective gearbox shafts are tight. CAUTION: BEFORE WORKING UNDER LOADING HOPPER, REST HOPPER ON SAFETY BOLTS. DO NOT FORGET TO REMOVE THESE BOLTS BEFORE RE-STARTING THE MACHINE Loader Magnetic Brake (see below for .. Range brake units.) adjust if necessary, to the following instuctions (these instructions apply only if separate brake unit is fitted, refer to the manufacturer if combined otor and brake unit is fitted):- Mounting: Set the brake so that the horizontal centre-line of the shoe corresponds with the centre-line of the brake wheel shaft and the shoe pivots are equally spaced from the vertical centre-line. Installing: Slacken back equalising screw (Item Slack nut (Item and adjust screw (Item to give required braking torque. WARNING: The end of the adjusting screw (Item must always be visible in the hole at the endof the adjusting nut (Item . Set nuts (Item so that contact is made with the load spring block in the shoe lever when solenoid plunger has moved through half its stoke. Once properly set, thissetting should not be altered. With solenoid plunger right down, set equalising screw(Item to give equal friction lining clearances. Tighten locknuts (Item 5 & Item and be sure that the load spring bracket is in place. Check adjustments frequently and lubricate brake shoe pivots. To adjust for wear, screw in adjusting screw (Item until the adjusting nuts are clear and only touchlever (Item when plunger is depressed