h position Data position of the Article No to B3SV-16-C Bevel-helical speed reducer B3

Flender/Flender Gear Units/Bevel-helical speed reducer B3

oil change see Item 1.2.4 Checking cooling coil for deposits. approx. every 2 yearssimultaneously with due oil change see Item 1.2.5 Checking tightness offastening bolts. after first oil change, then afterevery second oil change see Item 1.2.7 Carrying out complete inspectionof gear unit. approx. every 2 yearssimultaneously with due oil change see Item 1.3.1 Table 1.1: Maintenance and repair work 1.2 Description of maintenance and repair work1.2.1 Test water content of oil For detailed information on testing the oil for water content apply to the lubricant manufacturer. 1.2.2 Changing the oil As an alternative to the oil change intervals indicated in Table 1.1 it is, therefore, possible to have the oil sample tested at regular intervals by the Technical Service of the relevant oil company and to haveit released for further use. If reusability has been confirmed, no oil change will be necessary.Note: Please observe the separately attached Operating Instructions BA 7 EN. The instructions in item 7.1 must be observed! Drain the oil while it is still warm, .. immediately after shutting down the machinery. When changing the oil, always re-fill the gear unit with the same type of oil. Never mix different types of oil or oils made by different manufacturers. When changing the oil, the housing must be flushed with oil to remove sludge, metal particles and oil residue. Use the same type of oil as is used for normal operation. High-viscosity oils must be heatedbeforehand. Ensure that all residues have been removed before filling with fresh oil. Place suitable container under the oil drain plug of the gear-unit housing. Unscrew the air filter including reducing screw at the housing top.Caution! BA 5 EN 1.0Unscrew the oil drain plug and allow the oil to drain into the container. Drain the oil from the oil supply system. There is danger of scalding from the hot oil emerging from the housing. Wear protective gloves to avoid scalding.Remove an