Bevel-helical gear Reduction Box B3 caused by weight of gear unit on request Sizes B3-VV14A

Flender/Flender Gear Units/Bevel-helical gear Reduction Box B3

or- by temperature monitoring device in the oil sump with shut-off function. Note Any heat concentration must be prevented when using sunshade roof.When using temperature monitoring device, warning signal must be emitted when the maximum permitted oil sump temperature is reached. If the maximum permitted oil sump temperature is exceeded, the drive must be shut off.Such shutting off may cause the operator' plant to stop. NOTICE Property damage Damage to the gear unit from dropping objects, heaping over, welding work or inadequate fastening.The operator must ensure the following: - The gear unit must be protected against dropping objects and heaping over. - No welding work must be done at all on the drive.- The gear unit must not be used as an earthing point for electrical welding work. - All fastening points provided by the design of the unit must be used. - The screws having become useless in the context of assembly and disassembly works must be replaced by new screws of the same tightness class and model. Note To ensure proper lubrication during operation, the mounting position specified on the drawings mustalways be observed. 3 / 7BA 5 en 0/2.2 Unpacking NOTICE Property damage Damage to the gear unit from corrosion is possible. The packaging must not be opened or damaged beforehand if this is part of the preservation method. The products supplied are listed in the dispatch papers. Check immediately on receipt to ensure that all the products listed have actually been delivered. Parts damaged and/or missing parts must be reported to Siemens in writing immediately. Remove packaging material and transporting equipment and dispose of in accordance with regulations. Perform visual check for any damage and contamination. WARNING Serious physical injury from defective product If there is any visible damage, the gear unit must not be put into operation. The instructions in section 4. "Transport and storage", must be observed. 6.3 Assembly of the gear unit 6.3.1 Fit