B3-CV13-B values exact data acc to orderrelated documentat Bevel-helical gearbox B3

In stock
SKU
B3-CV13-B
$51,000.00

Flender/Flender Gear Units/Bevel-helical gearbox B3

perate at temperatures of the order of 4 above ambient temperature. Cable insulation of wiring installed in contact or near PV modules shall be rated accordingly. The calculation for the selectio of the conductor sizes & insu lation thickness to be submitted for approval Switching Devices All switching devices, shall comply with the following requirem ents: rated for .. use (especia lly when voltage is over 3 due to the risk of arcs); have voltage rating equal to or greater than 1.2 VOC ARRAY; not have exposed live metal pa rts in connected or disconnecte state; interrupt all poles, except in the case of pole connected ither to earth or to protective conductor. Disconnectors In addition to the requirements of switching devices, disconnec tors shall have current rating equal to or greater than the associated overcurrent protection device, or in the absence of such device, have current rating equal to or greate than the required current ca rrying capacity of the circuit to which they are fitted. (refer to Table for current calculation) In addition, circuit breakers and any other load breaking disconnection devices used for protection and/or disco nnecting means shall comply with the following requirements- Not be polarity sensitive (Fault currents in PV array may flo in the opposite direction of normal operating currents). Be rated to interrupt full load nd prospective fault currents from the PV array and any other connected Power sources such as batteries, generators and the rid if present. When overcurrent protection is incorporated, the trip current hall be rated according to IEC 6 Plug connections for interruption under load may also be used equivalent level of safety can be assured. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT TS NO.: MEC//2UU/0/2/0 Solar photo voltaic ( SPV) power sup
More Information
Model Type Bevel-helical gearbox B3
Gear Type Bevel Helical Gear
Weight (kg) 2380.000000
Ratio Range 1 : 12.5…71
Low Speed Output Solid shaft without parallel key
Nominal Torque 90700 Nm
Mounting Arrangements Vertical mounting position
Manufacturer Siemens Flender
Country of Manufacture Yemen
Data Sheet & Drawings B3-CV13-B values exact data acc to orderrelated documentat Bevel-helical gearbox B3