Bevel-helical gear Reduction Box B2 D GGD D N GGD D G dD kn x st c Flender GmbH B2-FH-18-A

In stock
SKU
B2-FH-18-A
$254,571.43

Flender/Flender Gear Units/Bevel-helical gear Reduction Box B2

ns: Absolutely no ground hunting or stalking shall be permitted on this property. Properly licensed persons hunting deer are authorized to take coyotes or foxes during the fall bow, permit bow, and winter bow seasons if the coyote or fox is encountered before said person has taken the season bag limit of deer. However, after the person has taken daily bag limit of deer he or she must cease hunting immediately. Properly licensed persons hunting deer who have valid turkey season permit from the New Jersey Division of Fish and Wildlife are authorized to take turkeys of either sex during the one week of the permit bow season that coincides with the fall turkey season if the turkey is encountered before said permittee has taken the season bag limit of deer. However, after the person has taken daily bag limit of deer he or she must cease hunting immediately. Hunting on Sundays shall be strictly prohibited. Permittees using elevated tree stands on Township property shall use full-body safety harness. . Saxon Ridge Designation: Block 1, Lots 1.0 and 1.0 Location: 1.4 acres located at the corner of Route 6 and Sunset Road, and on Saxon Way Seasons: This property shall be open to bow hunters during the dates established for bow hunting by the State of New Jersey for deer management zones 1 and 1 for 2-2 including fall bow, permit bow and winter bow. The specific dates on which hunting will be permitted are as follows, except that in the event any of the dates set forth below are inconsistent with any dates established by the State for the appropriate season, the State' dates shall apply, unless limited in specific instances by the Township of Montgomery in accordance with paragraph 2 of this Resolution: Fall bow: September 1 October 2, 2 Permit bow: October 2 December 2, 2 December 2 December 3, 2 Winter bow: January 1 February 1, 2 Permits: No more than four ( municipal de
More Information
Model Type Bevel-helical gear Reduction Box B2
Gear Type Bevel Helical Gear
Weight (kg) 11880.000000
Ratio Range 1 : 7.1…20
Low Speed Output Flanged shaft
Nominal Torque 230000 Nm
Mounting Arrangements Horizontal mounting position
Manufacturer Flender de Colombia
Country of Manufacture Colombia
Data Sheet & Drawings Bevel-helical gear Reduction Box B2 D GGD D N GGD D G dD kn x st c Flender GmbH B2-FH-18-A