Helical speed reduction gearboxes H4 ication is that the machinery and equipment menti H4-FV-11-A
In stock
SKU
H4-FV-11-A
$11,571.43
Flender/Flender Gear Units/Helical speed reduction gearboxes H4
l and open-loop control electrical devices corresponding to the specifications of the device supplier. Further information You can find additional
information on operation and maintenance in the associated operat- ing instructions, provided in the complete gear unit documentation. You can 
find the technical data of the mounted components in the contract-list of equipment provided in the complete gear unit documentation. 
5.6.2 Connecting the water-oil cooler 5.6 Connecting components NOTICE Damage to the water-oil cooler When installing the piping, it is 
not permissible that the connections of the water-oil cooler are subject to force, torque or vibration. Procedure To connect the water-oil cooler to the gear unit, proceed as follows: 1.Remove the connecting bushes from the cooling water connection before connecting the water-oil cooler. 2.Flush the water-oil cooler to remove any dirt and pollution. 3.Connect up the cooling water inlet and drain lines. Refer to the drawing for the direction of flow and the position of the connections. 4.Electrically connect the pressure monitor (only for appropriately equipped gear units). Further information You can find additional information on the water-oil cooler in the water-oil cooler unit operat- ing instructions, provided in the complete gear unit documentation. Assembly 5.6 Connecting components 5 Edition 0/2 A5-0 en Information Observe the information provided in chapter of the Mounted oil supply system with water-oil cooler ( Page . 5.6.3 Installing separate oil supply system 5.6 Connecting components Procedure To connect the oil supply system to the gear unit, proceed as follows: 1.Remove the dummy flange from the suction and delivery line before connecting the sys- tem. 2.Connect the system to the gear unit in accordance with the drawings in the complete documentation and install it as separate system. 3.When installing the system, make sure that the pipework is not subjected to mechanical stresses. More informati| Model Type | Helical speed reduction gearboxes H4 |
|---|---|
| Gear Type | Helical Gear |
| Weight (kg) | 540.000000 |
| Ratio Range | 1 : 100…355 |
| Low Speed Output | Flanged shaft |
| Nominal Torque | 61600 Nm |
| Mounting Arrangements | Vertical mounting position |
| Manufacturer | Siemens Industriegetriebe GmbH, Penig |
| Country of Manufacture | China |
| Data Sheet & Drawings | Helical speed reduction gearboxes H4 ication is that the machinery and equipment menti H4-FV-11-A |
