H3KH-25-C n eupex b110 Helical gear Reduction Box H3

Flender/Flender Gear Units/Helical gear Reduction Box H3

Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 2 of 2 as dies for threading conduits of diameters and threads corresp onding to the standards. The threaded ends of conduits shall be painted with anticorros ive paint. The outer ends shall be smoothened free of burrs and sharp edges. Bushings sha ll be fitted at both ends of conduits. Flexible metallic conduits shall be used for termination of con nections to motors and other electrical equipment like pressure switches etc. which ne ed to be disconnected at periodic intervals. All conduits shall be effectively connected to the earth termin al of the equipment where it terminates. Both ends of conduits shall be suitably earthed. Earthing conti nuity to be maintained by means of flexible wire whereve two conduits are joined with so ckets. Approved conduit bending machines to be arranged by the contrac tor shall be used for bending conduits at site. The radius of any conduit bend shall be as per standards for cabling. Bends shall be free from cracks, crimps or other damag coating. Annular space of used & un-used onduits should be sealed at bo th ends. 0.0 FACTORY TESTING Test on all equipment shall be conducted as per latest edition of Standards IS/ IPSS/ IEC/VDE/DIN/BS as applicable as per the respective equipment sp ecification. All external components and fitt ings that are likely to affect equipment shall be put in place during the factory test and the test shall be carried out at the manufacturers works, unless otherwise agreed between the urchase and the manufacturer. The contractor shall arrange to conduct Routine test/ Acceptan ce test as applicable on all equipment at manufacturer works per latest applicable standa rd as referred in technical specification. At least following routine tests, as listed belo , shall be conducted by the supplier for each supply. Any ad