H3-SH-23-D reductores flender mexico Helical speed reduction gearbox H3

Flender/Flender Gear Units/Helical speed reduction gearbox H3

can be ignited if the fan and air guide cover come into contact with one another as the cover has been incorrectly attached and sparks are generated. Make sure that the air guide cover is correctly fastened. It is not permissible that the fan and air guide cover come into contact with one another. DANGER An explosive atmosphere can be ignited An explosive atmosphere can be ignited if the gear unit overheats as result of inad- equate cooling. Avoid dust from depositing on the gear unit. Adapt the cleaning intervals to the operational situation. 8.3.5 Cleaning the coarse filter 8.3 Maintenance and servicing work Procedure To clean the coarse filter, proceed as follows: 1.Inspect the coarse filter. 2.Remove the drain plug. 3.Pull out the strainer and remove particles of dirt. 4.Replace any strainers or sealing rings that are defective. Further information You can find additional information about the coarse filter in the coarse filter operating in- structions provided in the complete gear unit documentation. You can find additional technical data in the separate data sheet and in the list of equipment provided in the complete gear unit documentation. Servicing 8.3 Maintenance and servicing work 7 Edition 0/2 B5-0 en8.3.6 Cleaning the double change-over filter 8.3 Maintenance and servicing work Procedure To clean the double change-over filter, proceed as follows: 1.Inspect the double change-over filter. 2.Follow the operating instructions for the double change-over filter. Further information You can find additional information about the double change-over filter in the double change- over filter operating instructions provided in the complete gear unit documentation. You can find additional technical data in the separate data sheet and in the list of equipment provided in the complete gear unit documentation. 8.3.7 Measuring the vibration levels of the rolling-contact bearings 8.3 Maintenance and servicing work Procedure Proceed as follows to measure the vibration l