H3-FV-5-D flender distributors Helical speed reduction gearbox H3

Flender/Flender Gear Units/Helical speed reduction gearbox H3

ervative agent and/or runningin oil in accordance with regulations. Remove any oil spillage immediately with an oilbinding agent. The oil must not come into contact with the skin (.. the operators hands). The safety notes on the data sheets for the oil used must be observed here! Screw in oildrain plug or reclose oildrain cock. Screw in any unscrewed residualoildrain plugs again. detailed view of the gear unit can be obtained from the drawings in the gearunit documentation. Fig. 6: Oil inlet/oil drain gear unit .. 1 1 Oil dipstick 3 Oildrain plug 2 Breather screw or screw plug 4 Oil inlet 8 / 1BA 5 en 0/2 1 Fig. 6: Oil inlet/oil drain gear unit .. 1 1 Oil dipstick 3 Oildrain plug 2 Breather screw or screw plug 4 Oil inlet Fig. 6: Oil inlet/oil drain aerator gear unit .BV Fig. 7: Oil inlet/oil drain aerator gear unit B3BV 1 Oil dipstick 4 Oil inlet 2 Breather screw or screw plug 5 Lubricating point 3 Oildrain plug 6 Greaselubricated rolling bearing detailed view of the gear unit can be obtained from the drawings in the gearunit documentation. 8 / 1BA 5 en 0/2.1.2 Filling with lubricant To fill with oil, unscrew the oil dipstick on the gear unit or oilequalising tank Using filter, fill the gear unit with fresh oil (max. mesh 2 ) up to the MAX mark on the oil dipstick. The quality of the oil used must meet the requirements of the separately supplied BA 7 operating instructions, otherwise the guarantee given by Siemens will lapse. We urgentlyrecommend using one of the oils listed in BA 7, because they have been tested and meet the requirements. Information on the type, quantity and viscosity of the oil is given on the rating plate on the gear unit. The oil quantity shown on the rating plate is to be understood as an approximate quantity. The marks on the oil dipstick must always be observed. In the case of gear units fitted with forced lubrication or an oilcooling system, the oil circuit must also be charged with oil. To do this, briefly start up the