Helical gear reducers H3 acoplamentos flender H3-CH6A

Flender/Flender Gear Units/Helical gear reducers H3

d and strapped with PVC perforated straps and suitably supported to keep it in position at the terminal blocks. All spare cores of each cable shall be segregated, marked spare, neatly dressed and suitably tapped at both ends. When the cores of two or more multicore cables take common ro ute in side equipment, cores of each cable shall be separately bound and the separate bundles neatly bound together. The contractor shall be responsib le for correct phasing of motor power connections and shall interchange connections at the motor terminals box, if ecessary, during each motor is test run. 0.0.1 Cable Joint/termination accessories ) For HT Cable The cable accessories shall include end termination kits, straight through joints and also any special tool and tackles and ccessories required for makin the joints/terminations. The straight through joint/termination arrangement shall be com plete with all fittings and consumables. The joint/ termination shall have electrical and echanical withstand capability, same as that of the associated cable. For all cable , minimum extra length of 2 metresshall be left before jointing. The termination/ jointing kit sh all be of heat shrinkable type, unless specified otherwise 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT ______________________________________________________________________________________________ TS NO.: MEC//2UU/0/2/0 Electrical system Chapter-0.0 2, MECON Limited, All Right Reserved Pag 2 of 2 in TS. The termination kits/straight through joints shall have the following features: Electrical stress control to be provided at the cable insulatio shield terminus. An external leakage insulation to be provided between the cable conductors and ground. Adequate protection to be provided at the end of the cables aga in