Helical gear units H3 flender h2sh H3-CH-8-D

In stock
SKU
H3-CH-8-D
$13,392.86

Flender/Flender Gear Units/Helical gear units H3

d by suitable measures. heat concentration must be avoided. This can be ensured as follows: - fitting sunshade roofor- fitting bed crossdraft design by average hybridtype vitreousnes an additional cooling unitor- by temperature monitoring device in the oil sump with shut-off function. Note Any heat concentration must Belt Loher Gesamt of mm LoherBaugren engrenages be prevented when using sunshade roof.When using temperature monitoring device, warning signal must be emitted when the maximumpermitted oil sump FYCCW change Dimensions specific ratio direction lbins temperature is reached. If the maximum permitted oil sump temperature is exceeded, the drive must be shut off. Such shutting to other Dimensions be the us included off may cause the operator' plant to stop. NOTICE Property damage Damage to the gear unit from dropping objects, heaping over, welding work or inadequate fastening.The operator must ensure the following:- The gear unit must be protected against dropping objects and heaping over. - No welding work must be done at all on the drive. - The gear unit must not be used as an earthing point for electrical welding work.- All fastening points provided by the design of the unit must be used.- The works relating to assembly and disassembly of screws that have become useless must be replaced by new screws of the same tightness class and model. Note To ensure proper lubrication during operation, the mounting position specified on the drawings mustalways be observed. 3 / 9BA 5 en 0/2.2 Unpacking NOTICE Property damage Damage to the gear unit from corrosion is possible. The packaging must not be opened or damaged beforehand if this is part of the preservation method. The products supplied are listed in the dispatch papers. Check immediately on receipt to ensure that all the products listed have actually been delivered. Parts damaged and/or missing parts must be reported to Siemens in writing immediately. Remove packaging material and transporting equipment and dispose of in accordance with regulations. Perform visual check for any damage and contamination. WARNING Serious physical injury from defective product If there is any visible damage, the ge
More Information
Model Type Helical gear units H3
Gear Type Helical Gear
Weight (kg) 625.000000
Ratio Range 1 : 31.5…112
Low Speed Output Solid shaft without parallel key
Nominal Torque 27200 Nm
Mounting Arrangements Horizontal mounting position
Manufacturer Flender France S.A.R.L.
Country of Manufacture Fiji
Data Sheet & Drawings Helical gear units H3 flender h2sh H3-CH-8-D