H2FH-4-C bipex coupling Helical gearboxes H2

Flender/Flender Gear Units/Helical gearboxes H2

ating and, if necessary, tighten it. The eye-bolt on the motor may be used only as auxiliary suspension, .. for horizontal mounting position of the motor, to transport the un- or demountedmotor. The permissible attaching weight is to be observed: 3 [mm] 3 4 5 6 7 9 1 8M 1 1 1 2 2 3 [kg] 1 2 3 7 1 3 Highest load exercised by the drive to be attached in kg with tension in the direction of the screw axis. To ensure maximum load-bearing capacity in direction of the lifting eye or eye bolt axis additional suitable transport means (cables or the like) must beused for transport and/or installation.Attention! Attention! BA G2 EN 0.0 1 / 4When attaching with several chains and ropes, two ropes must already be sufficient to support the complete load. Lifting devices such as ropes andsimilar should be secured against slipping. The threads in the shaft ends must not be used for attaching eye bolts for handling. Transport fixtures, if present, should be removed and stored or be made noneffective according to additional notes. For further transport reuse or make effective again. 4.3 Storage The drives should be stored in dry rooms with minimum temperature fluctuations in their positions of use on horizontal wooden support and covered. The storage area must be free of vibrations (shocks) as otherwise the anti-friction bearings may be damaged. It is not permissible to stack drives on top of one another. The gear units are provided with internal preservation, the free shaft ends and the flange surfaces are provided with protective coating. Note: Unless agreed to the contrary by contract, warranty period of 6 months is given for the standard preservation. The warranty period starts to run on the date of deliveryof the gear unit. In the case of prolonged interim storage (> 6 months) check preservation and renew it, if necessary (see Section 7. Startup). The contractually agreed external coating (Type, structure, colour) was carefully applied by spray painting. See 5.1 fo