H2-KH25-B flender germany address Helical gear boxes H2

Flender/Flender Gear Units/Helical gear boxes H2

are operated in combination with electrical machines that generate current or through which current flows (.. motors and generators), take measures to ensure that no current can flow through the gear unit. Current flowing through the gear unit can result in irreparable damage to rolling-contact bearings and gears. Short circuits, voltage flashovers and deposits of conductive dust, for example, can all allow current to flow. Use insulators and earth the gear unit properly. When removing any guards, store their fixings in safe place. Removed guards must be re-fitted prior to starting. Observe the notices mounted on the gear unit, .. rating plate, direction of rotation ar- row symbol, etc. The notices must be kept free from paint or dirt. Replace any missing, illegible or damaged plates. Screws which have become unusable during assembly and dismantling must be re- placed with new screws of the same strength class and design. DANGER Danger to life when the system is switched on Death or serious injury will occur. Always shut down the gear unit and any oil supply system (whether separate or attached to the gear unit) before you perform any work. Secure the drive aggregate against being operated accidentally as follows: Turn off the key-operated switch. Remove the fuses in the power supply. Attach an information notice to the start switch, clearly stating that work is being car- ried out on the gear unit. Ensure that the entire system is not under load to avoid danger during dismantling work. Further use of the gear unit When integrating the gear unit in machines or systems, the machine or system manufacturer is obliged to include the provisions, instructions and descriptions contained in this set of in- structions in their machine instructions. Safety instructions 2.6 Intended use 2 Edition 0/2 A5-0 en A5-0 en Edition 0/2 2Description 3 3.1 General description 3.1 General description The FLENDER gear unit (referred to below simply as "gear unit") described in these o