H2-FV-26B flender company profile Helical gear reducer H2

Flender/Flender Gear Units/Helical gear reducer H2

bore. Oil level Any oil escaping should be removed immediately with oil binding agent in an environmentally compatible way. For drives with only one plug screw, checking the oil level is not possible. 7.1.1.2 Oil sight glass (Special feature) If an oil inspection glass is provided, the oil level must be visible in the middle of the inspection glass Oil level 7.1.1.3 Dipstick (Special feature) Check oil level with dipstick: The oil level must be between the lower and upper mark of the dipstick. BA G2 EN 0.0 2 / 4.1.2 Startup without long term preservation MOTOX- drives are delivered with the appropriate lubricants ready for operation depending on the specified conditions of use. On gear systems with the required housing ventilation the required ventilator filter is delivered loose with the unit. It must be replaced with the appropriate screw plug before the initial start-up of the gear unit. It must be used at the position indicated by this symbol (see Section 3.. 7.1.3 Startup in case of long term preservation 7.1.3.1 Long term preservation up to 1 months Before starting up the gear unit, it should be filled with lubricant (see 7.1.. 7.1.3.2 Long term preservation up to 3 months The gear unit is completely filled with oil. Before the startup, the oil level should be corrected according to the type of construction. The oil level should be reduced to the level marked with this symbol (see 7.1.. Any oil escaping should be removed immediately with oil binding agent in an environmentally compatible way. 7.1.4 Filling with lubricant Screw out venting screw or venting filter or plug screw at the highest point (see 3.2 or point of ventilation). Fill gear unit up with fresh oil using filling filter (max. filter coarseness 6 ). The quantity of oil depends on the mounting position! Note: Recommendations on the oil to be used should be taken from Section 1. Maintenance and repair.Data, such as oil grade, oil viscosity and oil quantity required will be found on the