Flender/Flender Gear Units/Helical gear boxes H2
and depth of grain bed (Lang and Sokhansanj, . Clarkand Lamond ( determined the bulk volume shrinkage of wheat during
air drying ina 2-ft bed and presented the following relationship: /H1.8M ( whereXis bed shrinkage and Mis bed mean moisture 
reduction. Boyce ( pre- sented linear equation relating percentage shrinkage of barley bed to the average moisturecontent. The moisture of 
0.3- 2bed area of barley decreased from 3 to 1% during through-ow drying, and the following relation was developed: /H1.2/H1.6 
( where Mis mean bed moisture. Bala and Woods ( simulated deep-bed drying of malt in cylindrical container with bed height of 0.3 and diameter of 0.1 . Thebarley sample was dried at 5 with 1% relative humidity, and an exponential model was presented: Properties of Cereal Grains 2 /H1.9 (1 /H1e/H1.9M) ( Lang and Sokhansanj ( proposed shrinkage eqs ( and ( for wheat and canola dried from their initial moisture content of 9.1 and 6.4%, respectively: Wheat /H1.0/H1.3M ( Canola /H1.8/H1.9M ( where /H1Xi/H1X Xi/H1% and /H1Mi/H1M% ( They attributed the difference in bulk volume shrinkage to the differences in constituents of the two seeds. The canola seed contained 4% oil on mass basis; on the other hand,wheat kernel contained 6% carbohydrates of starch origin: starch is known to have higherafnity for water than oil. Lang and Sokhansanj ( also studied the effect of relativehumidity (2%) and air temperature (2 ) and related shrinkage coefcient, (/H1X/) with relative humidity ( RH) and temperature ( ): Wheat /H1.3/H1.4/H1/H1RH/H1.2/H1/H1T ( Canola /H1.9/H1.7/H1/H1RH/H1.3/H1/H1T ( The effects of relative humidity on shrinkage coefcient for wheat and canola were re- ported to be predominant, and temperature effects were statistically insignicant. 3 THERMAL PROPERTIES Thermal and moisture-transport properties are required for simulating heat and moisture transfer phenomena during drying and storage of grains. Variability in composition an| Model Type | Helical gear boxes H2 |
|---|---|
| Gear Type | Helical Gear |
| Weight (kg) | 6600.000000 |
| Ratio Range | 1 : 6.3…20 |
| Low Speed Output | Hollow shaft with shrink disk |
| Nominal Torque | 292000 Nm |
| Mounting Arrangements | Vertical mounting position |
| Manufacturer | Flender..Ltd China(Tianjin) |
| Country of Manufacture | Brazil |
| Data Sheet & Drawings | flender spojky H2-DV-19-D Helical gear boxes H2 |
Related Products
