H1-KV-11-D redutor flender Helical gear boxes H1

Flender/Flender Gear Units/Helical gear boxes H1

.1 Factory Acceptance Test .1.1 This test shall systematically, fully & functionally test all the hardware and software in the presence of Owner/consultant representative. All the sub systems shall be inter-connected to simulate, as close as possible, the total integrated system. Barrier cabinets shall be used as the connecting points for tes inputs and outputs. .1.2 The duration of the testing shall be mentioned by the vendor with reasons. System shall be shipped to site only after this testing and certified ready for dispatch by Owner/consultant. .1.3 Data Review ) Client/Consultant shall perform comparison of all current data. Any revision of changes required shall be informed to Vendor. ) The test report/log book forwarded by Vendor after Shop Internal Testing shall be reviewed. Client / Consultant has rig ht to witness any test performed in shop internal testing, if foun necessary. .1.4 Testing Record During Factory Acceptance Testin each test carried out shall be recorded. Any deficiency or problem shall be clearly brought out and shall be corrected. Any change in the data or configuration etc. informed to the vendor shall be recorded and carried out by the vendor. .1.5 Visual and mechanical testing ) Visual and mechanical testin shall be carried out in rinciple to assure correct, proper, good nd neat workmanship by the vendor. 1 of 1 INDRADHANUSH GAS GRID LIMITED TECHNICAL SPECIFICATION FOR NATURAL GAS COMPRESSOR STATION FOR NORTH EAST GAS GRID PIPELINE PROJECT TS NO.: MEC//2UU/0/2/0 Control & Instru mentation (&) Chapter-0.0 2, MECON Limited, All Right Reserved Page 1 of 1 ) The following shall be checked: The solutions used for limiting the amount of dust that enters the cabinets, the degree of electrical protection of the cabine ts and components (degree of dielectric strength of the wired cabinets and of t