the letter Z and the following order codes must b B4-VV-27B Bevel-helical gear boxes B4

Flender/Flender Gear Units/Bevel-helical gear boxes B4

TENTIONALLY BLANK PAGE INTENTIONALLY BLANK PAGE INTENTIONALLY BLANK PAGE OPERATING AND MAINTENANCE MANUAL SECTION 6 ELECTRICAL SYSTEM ELECTRICAL INFORMATION 1. The mixing pan and mixing star motors should be interconnected in the control to operate at the same time, as it is important that both are working before mixis added. Ensure that suitable overloads are fitted. The mixing pan and mixingstar rotate anti-clockwise when looking from the top. NOTE: With motors 5.5 kw and above, use Star Delta Starters. Below this, use Direct on Line Starters. 2. When loader is attached direct on line reversing starter is required complete with suitable overloads. The loader winch rotates anti-clockwise looking fromthe rope drum end and when the raise button is pressed. The upper and lower limit switches are positioned to break the electrical supply to the loader motor when the loading hopper is in the required position at thetop and bottom of the runway. 3. The door control solenoid has to be energised when the mixer door is required in the open position. It is advisable to mount the starters away from the machine on supports free from vibration. 4. IMPORTANT NOTICE: All work on plant electrics including control panel circuits to be under taken by suitably qualified and competent electricalperson. All wiring in exposed positions should be suitably protected orarmoured cable and protected by suitable earth leakage circuit breaker. 5. The Mixing Star Dive and Pan Drive should be interconnected in order to start in the following sequence:- Mixing Star Motor Pan Drive Motor 6. When Whirler is fitted the sequence should be:- Whirler Motor Mixing Star Motor Pan Drive Motor RP2XD FLENDER MOTOR WIRING DIAGRAM