Bevel-helical speed reducers B4 rication by motor pump LP B V Dip lubricat B4-SV-9B
In stock
SKU
B4-SV-9B
$19,071.43
Flender/Flender Gear Units/Bevel-helical speed reducers B4
STATION EMERGENCY WORK Page 1 Training The contractor shall provide training for the MCC and all electrical and electronic equipment
used. This training shall not be sales pitch but an in-depth training session by the agent of the equipment. PS1 
CABLING ) Signal cable - suitable armoured screened twisted pair signal cable 1 mm2 - for the connection of the 
transducer to the transceiver in the MCC. The connection to be done via 1 No. CCG connection box mounted in 
the sump area. ) Suitably sized armoured cables for the power supply to the pumps from the MCC to the respective motor terminals shall be 5m and 6m respectively for pump no.1 and pump no.4. Installation and connection to be complete with 3CR1 cable ladder . ) Suitably sized armoured cables to accommodate the connection of the thermistors and moisture probe connections of each pump to the MCC. ) ) On completion of installation all cable ducts are to be sealed off with polyurethane foam type sealer. Motor cables to be as per OEM requirements. PS1 CERTIFICATE OF COMPLIANCE The person issuing the certificate shall perform the testing of the installation with an EWS staff member being present. certificate of compliance is required for the motor control centre and all circuits and sub circuits connected to the MCC and the sub-distribution board. The person issuing the certificate shall perform the testing of the installation with an EWS staff member being present. Type test certificate issued or copy thereof. PS1 TESTING PS1.1 General No test will be recognised unless it is documented in an agreed format. The test procedure shall ensure that every combination of switches and events is tested for correct functioning and each such combination will be on the test sheet and checked off. The contractor shall supply all test equipment and consumables. The contractor shall conduct tests at the following stages. The engineer shall be advi| Model Type | Bevel-helical speed reducers B4 |
|---|---|
| Gear Type | Bevel Helical Gear |
| Weight (kg) | 890.000000 |
| Ratio Range | 1 : 80…315 |
| Low Speed Output | Solid shaft with parallel key acc. to DIN 6885/1 |
| Nominal Torque | 35700 Nm |
| Mounting Arrangements | Vertical mounting position |
| Manufacturer | FLENOER-GRAFFENSTA |
| Country of Manufacture | Austria |
| Data Sheet & Drawings | Bevel-helical speed reducers B4 rication by motor pump LP B V Dip lubricat B4-SV-9B |
Related Products
