Bevel-helical gear units B4 Z QF Side Taconite FSide Special seal order via B4-HV-14-D

Flender/Flender Gear Units/Bevel-helical gear units B4

torque housing nut 2 NmWire LiYY , 2 ; 2 0.5 mm Vibration strength 5 Hz (1 mm)Shock resistance 3 (1 ms)Type of protection IP 6 If other pulse generators are used, the relevant data sheet in the documention must be consulted for the technical data! Connection: The pulse generator and speed monitor are connected by twin-core cable. The max. cable length is with 1.0 mm 2 cross section 5 . The feed cable is always separate and must not be incorporated into multi-core cables (risk of coupling disturbing voltages in).Caution! Caution! BA 1 EN 1.0.2 Connection, operation and setting of the evaluating instrument (speed monitor) 5.2.1 Terminal assignment 1 - 2 Operating voltage connection 3 - 5 Limit relay output6 - 8 Fault signal relay, is de-energised in the event of fault (wire breakage or short circuit) 9 - 1 Sensor connection in accordance with block diagram (III: 1-1 = 1 to 1k ) 9 bu, 1 bnPulse generator connection of the EWD system 1 Continuous switching output for further transmission of the sensor switching condition1 - 1 Programming the speed monitoring system: Open bridge: Monitoring for too low speed, limit relay de-energised in the event of too low speed. Closed bridge: Monitoring for too high speed, limit relay de-energised in the event of too high speed. 1 - 1 Delayed timing (only with monitoring for too low speed): If the operating voltage is switched on with the bridge closed or the bridge closed with the operating voltage on, the limit relay will be forcibly energised for the period of timeset on the AU rotary switch and the Speed too low signal blocked in the starting phase. Dynamic transmitter-circuit monitoring: If during the monitoring for excessive speed and with the bridge closed no pulses areemitted for the time set on the AU rotary switch, the two output relays are de-energised. BA 1 EN 1.0.2.2 LED display function and function setting Readiness for operation Pulse indication Switching conditionSetting factor T