Bevel-helical gear reducer B4 esign GMDXX Variants of Taconite sealsApplicati B4-HH-16-D

Flender/Flender Gear Units/Bevel-helical gear reducer B4

tion or assembly cover and remove the cover (including seal) from the housing. Do not discard the seal. Using filter, fill the gear unit with fresh oil (max. mesh 2 m) up to the MAX mark on the oil-level sight glass. Note: For the correct type of oil (of various brands) to be used, refer to the BA 7 EN operating instructions supplied separately.Information on the type, quantity and viscosity of the oil is given on the rating plate on the gear unit.The quantity of oil indicated on the rating plate is an approximation only. The markson the oil-level sight glass must always be observed. Note: In the case of gear units fitted with forced lubrication or an oil-cooling system, the oil circuit must also be charged with oil. To do this, briefly start up the gear unit withadd-on pump as described in section 8. Check the oil level in the gear housing. Note: The oil level must be within the limits of the marks on the oil-sight glass. Remove any oil spillage immediately with an oil-binding agent.Place the inspection or assembly cover (including seal) on the housing and replace and tighten the fastening bolts (see item 1.2.. 7.2 Start-up Note: After the first start-up of the external oil cooling system check the oil level. Check the oil level in the gear unit. Note: When the oil is cool, the level should be at the upper oil sight glass mark. When the oil is warm it may slightly exceed this mark. It must in no case be allowedto fall below the mark. If necessary, top up to the correct level.Caution! Caution! Caution! BA 5 EN 1.0.2.1 Gear unit with cooling coils or water oil-coolers Note: Prior to start-up make sure that the permissible pressure and temperature values as stated in the order-specific data sheet are not exceeded. Fully open the stop valves in the coolant in- and outflow pipes. It should be checked that all connecting lines are tightly bolted. Note: Refer to the order-specific dimensioned drawing for connecting dimensions. The coo