B4-DH-25-D n be shut down for safety reasons Forced lubricat Bevel-helical gear units B4

Flender/Flender Gear Units/Bevel-helical gear units B4

uantity of parts required The full address to which the parts are to be sent Winget Limited can accept no responsibility for incorrectly supplied spare parts unless the part number and full description of the items required is given when the order is placed. IMPORTANT NOTICE The CUMFLOW RP2XD is high performance mixer The following precautions are necessary to obtain the best results and to avoid damage to the MIXING STAR and PAN DRIVE ENSURE TRANSIT BAR AND RING ARE REMOVED FROM DOOR BEFORE STARTING MACHINE. AGGREGATES Strict control of graded aggregates must be maintained Maximum size 1mm Oversize lumps of aggregate or rogue materials must be prevented from entering the Pan MIXING STAR BLADES They are to special shape and material to prolong wear life. They should not be modified in any way and only replaced with GENUINE CROKER spares Obtained from WINGET LIMITED. daily check is advisable to ensure that the Blades/Wearing parts are secure and undamaged. PAN RIM & BASE WEARING PLATES They must be replaced before excessive wear causes distortion.MAXIMUM BATCH LOADS UNDER NO CIRCUMSTANCES should the Maximum Batch Loads quoted be exceeded nor should the mixer be or re-started when there is mix in the Pan MIXING PAN Ensure that the Mixing Pan is rotating concentrically and that the pan base is Rotating in horizontal place, otherwise damage may occur to the doormechanics. WARNING THE MANUFACTURER ACCEPTS NO RESPOSIBILITY FOR ANY DAMAGE OR FAILURE RESULTING FROM OPERATIONAL MISUSE OR MALPRACTICE. ANY MODIFICATIONS TO THE MACHINE WILL AFFECT ITS WORKING PARAMETERS AND SAFETY FACTORS. REFER TO THE MANUFACTURERS BEFORE FITTING ANY NON STANDARD EQUIPMENT OR PARTS. THE MANUFACTURERS ACCEPT NO RESPONSIBILITY FOR ANY MODIFICATIONS MADE AFTER THE MACHINE HAS LEFT THE FACTORY, UNLESS PREVIOUSLY AGREED IN WRITING. THE MANUFACTURERS WILL ACCEPT NO LIABILITY FOR DAMA