B4-DH-22-A l order via order code Y Z QJ Side Special seal Bevel-helical gear Reduction Box B4

Flender/Flender Gear Units/Bevel-helical gear Reduction Box B4

type. Spare parts should always be obtained from FLENDER (refer also to section . BA 5 EN 1.0.3 Environmental protection When changing oil, the used oil must be collected in suitable containers. Any spillage of oil must be removed immediately. Preservative agent should be stored separately from used oil. Used oil, preservative agent, oil-binding agents and oil-soaked cloths must be disposed of in accordance with environmental legislation. 3.4 Special dangers Depending on operating conditions, the surface of the gear unit may heat up considerably. Danger of burns! When changing oil, take care to prevent scalding by hot oil. Small foreign matter such as sand, dust, etc. can get into the cover plates of the rotating parts and be thrown back by these. Eye protection must therefor be worn while the gear unit is operating. The gear unit is not suitable for operation in explosion hazard locations. When operating in explosion hazard locations special additional safety proceduresmust be observed. 3.5 Warnings and symbols used in these Operating Instructions This symbol indicates safety measures which must be observed to avoid personal injury. This symbol indicates safety measures which must be observed to avoid damage to the gear unit. Note: This symbol indicates general operating instructions which are of particular importance. 4. Handling and storage Observe the Safety instructions in section 3. 4.1 Scope of supply The products supplied are listed in the despatch papers. Check immediately on receipt to ensure that all the products listed have actually been delivered. Parts damaged during transport or missing partsmust be reported in writing immediately to FLENDER AG. If damage has occurred, the gear unit must not be put into operation.Caution! Caution! Caution! BA 5 EN 1.0.2 Handling When handling FLENDER products, use only lifting and handling equipment of sufficient load-bearing capacity!Observe the notes regarding lo