CN or higher strength Shrink disk on machine sid B4-CV8-B Bevel-helical gear Reduction Boxes B4

Flender/Flender Gear Units/Bevel-helical gear Reduction Boxes B4

the MIN marking on the oil dipstick be fallen short of. Fill up oil if necessary. Note The oil level in the oil supply system must be checked.For this purpose, the operating instructions of the oil supply system must be observed. 5 / 7BA 5 en 0/2.3 Irregularities NOTICE Property damage Damage to the gear unit from error states is possible. Turn off the drive unit immediately in the cases stated below. If irregularities are found during the operation. If the pressure monitor in the oil-supply system triggers alarm. Note Determine the cause of the fault, using table 1 "Faults, causes and remedy" (see item 9..Table 1 "Faults, causes and remedy", contains list of possible faults, their causes and suggested remedies. If the cause cannot be found, specialist from one of the Siemens customer-service centres shouldbe called in (see section 2. "General notes"). 5 / 7BA 5 en 0/2. Faults, causes and remedy Observe the instructions in section 3. "Safety instructions" and in section 1. "Maintenance and repair"! 9.1 General information on faults and malfunctions Faults and malfunctions occurring during the guarantee period and requiring repair work on the gear unit must be carried out only by Siemens customer service. If faults and malfunctions occur after the guarantee period, the cause of which cannot be precisely identified, we advise our customers to contact our customer service. NOTICE Property damage Damage to the gear unit from improper use is possible. Siemens will not be bound by the terms of the guarantee or otherwise be responsible in cases of improper use of the gear unit, modifications carried out without the approval by Siemens or use of spare parts not originally supplied by Siemens. DANGER Danger to life from switched on system For carrying out work on the gear unit, the gear unit must generally be set in standstill.The drive unit must be secured against unintentional start-up. notice should be attached to the start switch stating clearly that work is in prog